Home › Vehicle Exterior › WINDOW / GLASS › RELAY

RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT FRONT WIPER DEICER RELAY


E109078E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    When battery voltage not applied
    10 kΩ or higher
    3 - 5
    Apply battery voltage to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the front wiper deicer relay.



2. INSPECT DEFOGGER RELAY


E106620E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    When battery voltage is not applied
    Below 1 Ω
    3 - 4
    When battery voltage applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    When battery voltage is not applied
    10 kΩ or higher
    3 - 5
    When battery voltage applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the defogger relay.