Home › Vehicle Interior › SEAT › REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side)

REAR NO. 2 SEAT ASSEMBLY (for Power Seat Type LH Side) > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY


    B190118
  1. Raise the handle, detach the 4 guides and remove the No. 2 deck board.



2. REMOVE LUGGAGE COMPARTMENT TRIM BOX


    B194633
  1. Remove the 4 caps.



    B190116
  1. Remove the 4 bolts and luggage compartment trim box.



3. REMOVE ROPE HOOK ASSEMBLY


    B191405
  1. Remove the bolt and rope hook.

    HINT:
    Use the same procedure for both sides.



4. REMOVE NO. 1 DECK BOARD SUB-ASSEMBLY


    B190117
  1. Detach the 5 clips and remove the No. 1 deck board.



5. REMOVE DECK BOARD REINFORCEMENT SUB-ASSEMBLY


    B190120
  1. Remove the 4 bolts and deck board reinforcement.



6. REMOVE DECK BOARD BRACKET


    B190119
  1. Remove the 2 bolts and deck board bracket.



7. REMOVE SEAT TRACK BRACKET FRONT COVER OUTER


    B193987E02
  1. Detach the 2 claws and 2 guides in the order shown in the illustration, and then remove the seat track bracket front cover outer.



8. REMOVE SEAT TRACK BRACKET FRONT COVER INNER


    B232092E01
  1. Detach the clip, claw and 2 guides in the order shown in the illustration, and then remove the seat track bracket front cover inner.



9. REMOVE REAR NO. 2 SEAT ASSEMBLY LH


    B222249
  1. Pull the center belts out from the bottom of the seat cushion.



    B193989
  1. Remove the 2 bolts.



    B193992
  1. Remove the 2 bolts.

  1. Disconnect the connector.

  1. Remove the rear No. 2 seat assembly LH from the vehicle.

    NOTICE:
    Be careful not to damage the vehicle body.