Home › Vehicle Interior › SEAT BELT › REAR NO. 2 SEAT OUTER BELT ASSEMBLY

REAR NO. 2 SEAT OUTER BELT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the RH side.



1. INSTALL REAR SEAT OUTER BELT ANCHOR BRACKET ASSEMBLY RH


    B194794
  1. Align the rear seat outer belt anchor bracket positioning claw with the hole, and install the rear seat outer belt anchor bracket with the 2 bolts.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



2. INSTALL REAR ROOF NO. 1 AIR DUCT (for RH Side)


    B194793
  1. Install the rear roof No. 1 air duct with the 3 clips.



3. INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY RH


    B194792E01
  1. Align the claws on the body with the rear No. 2 seat outer belt retractor positioning holes.

  1. Install the rear No. 2 seat outer belt with the 2 bolts.

    HINT:
    First install bolt A, and then install bolt B.

    1. for Bolt A

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

    1. for Bolt B

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



    B194791
  1. Install the shoulder anchor to the rear seat outer belt anchor bracket with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }



4. INSTALL REAR SEAT SHOULDER BELT GUIDE


    B194790
  1. Install the rear seat shoulder belt guide with the 2 screws.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



5. INSTALL QUARTER SIDE SPEAKER ASSEMBLY (for RH Side)


    E161055
  1. Install the quarter side speaker RH with the 2 bolts.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62 in.*lbf }

  1. Attach the guide.

  1. Connect the connector.



6. INSTALL REAR SIDE NO. 1 AIR DUCT (for RH Side)


    I104303
  1. Install the air duct with the clip.

  1. Attach the clamp.



7. INSTALL COVER SUB-ASSEMBLY (for RH Side)


    I104302
  1. Attach the 2 claws to install the cover.



8. INSTALL QUARTER TRIM BRACKET RH (for RH Side)


    I104301
  1. Install the quarter trim bracket with the 2 bolts.

  1. Attach the clamp.



9. INSTALL POWER BACK DOOR UNIT ASSEMBLY (w/ Power Back Door)


    B192141
  1. Install the power back door unit with the 4 bolts.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }

  1. Connect the connector.



10. INSTALL POWER BACK DOOR ROD (w/ Power Back Door)


B194234
  1. Install the power back door rod with the 2 stop rings.



11. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH
  1. Install the curtain shield airbag assembly (Click here).