FUEL LID OPENER MOTOR ASSEMBLY > REMOVAL |
| 1. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Manual Seat) |
| 2. REMOVE REAR NO. 2 SEAT ASSEMBLY LH (for Power Seat) |
| 3. REMOVE REAR SEAT CUSHION HINGE LOWER COVER LH |
| 4. REMOVE REAR FLOOR STEP NO. 1 COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cap.
| 5. REMOVE REAR FLOOR STEP NO. 2 COVER |
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cap.
| 6. REMOVE REAR DOOR SCUFF PLATE LH |
| 7. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH |
| 8. REMOVE ROPE HOOK ASSEMBLY |
![]() |
Remove the bolt and rope hook.
| 9. REMOVE REAR FLOOR MAT SUPPORT PLATE |
![]() |
Detach the 5 clips and 4 claws, and remove the rear floor mat support plate.
| 10. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Manual Seat) |
![]() |
Detach the 3 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cover.
Remove the 2 bolts and 2 clips.
Detach the 11 clips.
Disconnect the connector and remove the quarter trim panel.

| 11. REMOVE QUARTER TRIM PANEL ASSEMBLY LH (for Power Seat) |
![]() |
Detach the 3 claws and remove the outer lap belt anchor cover.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Remove the bolt and outer lap belt anchor.
![]() |
Using a screwdriver with its tip wrapped in protective tape, detach the 2 claws and remove the cover.
Remove the 2 bolts and 2 clips.
Detach the 2 clamps and remove the wire harness.
Detach the 11 clips and 2 clamps.
Disconnect the 5 connectors and remove the quarter trim panel.

| 12. REMOVE W/ BOX NO. 1 SPEAKER ASSEMBLY (for 14 Speakers) |
![]() |
Disconnect the connector.
Remove the 4 bolts and the w/box No. 1 speaker.
| 13. REMOVE FUEL LID WITH MOTOR LOCK ASSEMBLY |
![]() |
Turn the cable counterclockwise and disconnect the cable from the fuel filler opening lid lock retainer.
![]() | Turn |
![]() | Pull Out |
![]() |
Remove the bolt.
![]() |
Disengage the clip and guide.
Disconnect the connector and remove the fuel lid with motor lock assembly.
| 14. REMOVE FUEL FILLER OPENING LID LOCK RETAINER |
![]() |
Turn the fuel filler opening lid lock retainer clockwise and remove the fuel filler opening lid lock retainer.
![]() | Turn |
![]() | Pull Out |