CLEARANCE SONAR MAIN SWITCH > INSTALLATION |
| 1. INSTALL DRIVE MONITOR SWITCH |
![]() |
Attach the 2 claws to install the drive monitor switch.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL |
Attach the 12 clips to install the finish panel.
Connect the 2 connectors and clamp.
Attach the 4 claws to install the instrument panel finish panel retainer.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH |
Attach the 2 claws to install the sensor.
Connect the connectors.
Attach the 9 clips and claw to install the finish panel.
Install the 2 <A> bolts.
| 4. INSTALL INSTRUMENT SIDE PANEL LH |
| 5. INSTALL COWL SIDE TRIM BOARD LH |
| 6. INSTALL FRONT DOOR SCUFF PLATE LH |