Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR BELT MOULDING

BACK DOOR BELT MOULDING > INSTALLATION

for Preparation Click here



1. INSTALL BACK DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B195693
  1. Attach the 9 claws to install the back door glass outer weatherstrip.



2. INSTALL REAR WIPER STOPPER


B190526
  1. Attach the claw and guide to install the liner wiper step.



3. INSTALL BACK DOOR OUTSIDE MOULDING LH


    B191708
  1. Attach the 5 clips to install a new back door outside moulding.



4. INSTALL BACK DOOR OUTSIDE MOULDING RH

HINT:
Use the same procedure as for the LH side.