BACK DOOR BELT MOULDING > REMOVAL |
| 1. REMOVE BACK DOOR OUTSIDE MOULDING LH |
![]() |
Detach the 5 clips and remove the back door outside moulding.
| 2. REMOVE BACK DOOR OUTSIDE MOULDING RH |
| 3. REMOVE REAR WIPER STOPPER |
![]() |
Detach the claw and guide, and remove the linear wiper step RH.
| 4. REMOVE BACK DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |
![]() |
Apply protective tape to the door panel in the area around the back door glass outer weatherstrip.
![]() |
Using a moulding remover, detach the 9 claws and remove the back door glass outer weatherstrip.