Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BACK DOOR BELT MOULDING

BACK DOOR BELT MOULDING > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR OUTSIDE MOULDING LH


    B191708
  1. Detach the 5 clips and remove the back door outside moulding.



2. REMOVE BACK DOOR OUTSIDE MOULDING RH

HINT:
Use the same procedure as for the LH side.



3. REMOVE REAR WIPER STOPPER


    B190526
  1. Detach the claw and guide, and remove the linear wiper step RH.



4. REMOVE BACK DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    B195691E01
  1. Apply protective tape to the door panel in the area around the back door glass outer weatherstrip.



    B195692E01
  1. Using a moulding remover, detach the 9 claws and remove the back door glass outer weatherstrip.