DTC C1439/66 Steering Angle Sensor Initialization Incomplete |
DTC C1445/66 Vehicle Driven with Steering Angle Sensor not Initialized |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1439/66 | After the steering angle sensor zero point calibration data is cleared due to, for example, fluctuations in the power source, the steering angle zero point is not obtained after 60 seconds of continuous driving |
|
| C1445/66 | Steering angle sensor zero point is not obtained when the vehicle is driven without a record of steering angle sensor zero point calibration at a speed of 36 km/h (22 mph) or more for 30 seconds or more without the brake pedal being depressed |
|


| 1.CHECK DTC |
Clear the DTC (Click here).
Turn the ignition switch off.
Turn the ignition switch to ON again and check that no CAN communication system DTC is output.
Drive the vehicle at a speed of 36 km/h (22 mph), turn the steering wheel to the right and left and check that no speed sensor or yaw rate and deceleration sensor DTCs are output (Click here).
| Result | Proceed to |
| DTC (C1439/66 and/or C1445/66) output | A |
| DTC output (relating to CAN communication system) | B |
| DTC output (relating to speed sensor or yaw rate and deceleration sensor) | C |
| DTC not output | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds.
Check that the centered position of the steering wheel is correctly set while driving straight ahead.
| NEXT | |
| 3.RECONFIRM DTC |
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 4.REPLACE STEERING ANGLE SENSOR |
Replace the steering angle sensor (Click here).
| NEXT | |
| 5.PERFORM STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Drive the vehicle straight ahead at 40 km/h (25 mph) or more for at least 10 seconds.
Check that the centered position of the steering wheel is correctly set while driving straight ahead.
| NEXT | |
| 6.RECONFIRM DTC |
Clear the DTC (Click here).
Start the engine.
Drive the vehicle at a speed of 35 km/h (22 mph) or more and turn the steering wheel to the right and left.
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC is output | A |
| DTC is not output | B |
|
| ||||
| A | ||
| ||