Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > TRC OFF Indicator Light Remains ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via the CAN communication system.

WIRING DIAGRAM


C244860E03


INSPECTION PROCEDURE

NOTICE:
When replacing the VSC actuator assembly, perform zero point calibration (Click here).

1.INSPECT CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).
    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC (FOR SFI SYSTEM)
  1. Clear the DTC (SFI system) (Click here).

  1. Check the DTC (SFI system) (Click here).
    Result 
    Result
    Proceed to
    DTC (SFI system) is not output
    A
    DTC (SFI system) is output
    B



B
GO TO SFI SYSTEM (DIAGNOSTIC TROUBLE CODE CHART) (Click here)
A


3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER (TRC(TRAC) OFF INDICATOR LIGHT)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester on.

  1. Select the Active Test mode and operate the TRC OFF indicator light using the intelligent tester.

    ABS/VSC/TRC  
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    TRC(TRAC) OFF Indicator Light
    TRC OFF indicator light
    Indicator light ON / OFF
    Observe combination meter

  1. Check that the TRC OFF indicator light turns on and off in the combination meter when using the intelligent tester.

    OK:
    The TRC OFF indicator light turns on and off in accordance with the intelligent tester operation.

    HINT:
    When the TRC OFF indicator light remains illuminated, there may be an open in the wire harness of the combination meter or abnormalities in the meter circuit.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK

REPLACE VSC ACTUATOR ASSEMBLY (Click here)