REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type) > TERMINALS OF ECU |
| CHECK INNER REAR VIEW MIRROR ASSEMBLY |

Disconnect the U12 inner rear view mirror assembly connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| U12-1 (IG) - U12-2 (E) | SB - W-B | Ignition switch signal | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V | |||
| U12-2 (E) - Body ground | W-B - Body ground | Ground | Always | Below 1 Ω |
Reconnect the U12 inner rear view mirror assembly connector.
Measure the voltage according to the value(s) in the table below.
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
| U12-3 (REV) - U12-2 (E) | LG - W-B | Reverse signal | Ignition switch ON, shift lever in R | 11 to 14 V |
| Ignition switch ON, shift lever not in R | Below 1 V | |||
| U12-6 (CV-) - Body ground | Shielded - Body ground | Shielding | Always | Below 1 V |
| U12-7 (CV+) - U12-6 (CV-) | R - Shielded | Display signal | Ignition switch ON, shift lever in R | Waveform 1 |
| Ignition switch ON, shift lever in R, screen blacked out by covering camera lens | Waveform 2 | |||
| U12-14 (CB+) - U12-13 (CGND) | B - W | Power source | Ignition switch ON, shift lever in R | 5.5 to 7.05 V |
![]() |
Using an oscilloscope, check waveform 1.
| Item | Content |
| Terminal No. (Symbol) | U12-7 (CV+) - U12-6 (CV-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, shift lever in R |
![]() |
Using an oscilloscope, check waveform 2.
| Item | Content |
| Terminal No. (Symbol) | U12-7 (CV+) - U12-6 (CV-) |
| Tool Setting | 0.2 V/DIV., 50 μs/DIV. |
| Condition | Ignition switch ON, shift lever in R, screen blacked out by covering camera lens |