Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type)

REAR VIEW MONITOR SYSTEM (for Inner Rear View Mirror Type) > Display Signal Circuit between Inner Rear View Mirror Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit of the television camera.

WIRING DIAGRAM


E190525E06


INSPECTION PROCEDURE

1.CHECK INNER REAR VIEW MIRROR ASSEMBLY
E173535E03
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    U12-14 (CB+) - U12-13 (CGND)
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V



NG
REPLACE INNER REAR VIEW MIRROR ASSEMBLY (Click here)
OK


2.CHECK REAR TELEVISION CAMERA ASSEMBLY

E173337E07

  1. Using an oscilloscope, check the waveform.
    Measurement Condition 
    Item
    Content
    Terminal No. (Symbol)
    U12-7 (CV+) - U12-6 (CV-)
    Tool Setting
    0.2 V/DIV., 50 μs/DIV.
    Condition
    1. Ignition switch ON, shift lever in R*1
    2. Ignition switch ON, shift lever in R, screen blacked out by covering camera lens*2

    OK:
    Waveform is as shown in illustration.



NG
Go to step 3
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

3.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR - TELEVISION CAMERA)
E258528E02
  1. Disconnect the U12 inner rear view mirror assembly connector.

  1. Disconnect the V23 rear television camera assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    U12-14 (CB+) - V23-5 (CB+)
    Always
    Below 1 Ω
    U12-13 (CGND) - V23-5 (CGND)
    Always
    Below 1 Ω
    U12-7 (CV+) - V23-3 (CV+)
    Always
    Below 1 Ω
    U12-6 (CV-) - V23-2 (CV-)
    Always
    Below 1 Ω
    U12-14 (CB+) - Body ground
    Always
    10 kΩ or higher
    U12-13 (CGND) - Body ground
    Always
    10 kΩ or higher
    U12-7 (CV+) - Body ground
    Always
    10 kΩ or higher
    U12-6 (CV-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)