REAR VIEW MONITOR SYSTEM (w/o Navigation System) > Inner Rear View Mirror Power Source Circuit |

| 1.CHECK HARNESS AND CONNECTOR (INNER REAR VIEW MIRROR - BATTERY AND BODY GROUND) |
![]() |
Disconnect the U12 inner rear view mirror assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| U12-1 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U12-2 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||