Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B15A0    LAN Master Malfunction

DTC    B15AD    Navigation Processor Malfunction

DTC    B15B0    Display Screen Malfunction

DTC    B15B3    Radio Tuner Malfunction

DTC    B15B4    CD Changer Malfunction

DTC    B15B5    DVD Changer Malfunction

DTC    B15B7    Bluetooth Module Malfunction

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC Code
DTC Detection Condition
Trouble Area
B15A0
When either of the conditions below is met:
  1. Bus malfunction
  2. EEPROM error
Navigation receiver assembly
B15AD
When one of the conditions below is met:
  1. Short to ground or +B, or open occurs in gyro signal circuit
  2. Gyro sensor malfunction
  3. GPS receiver malfunction
B15B0
Picture circuit (TFT unit) malfunction
B15B3
When one of the conditions below is met:
  1. AM tuner PLL is unlocked
  2. FM tuner PLL is unlocked
  3. Tuner malfunction
B15B4
When one of the conditions below is met:
  1. Mechanical communication error
  2. Load/Eject malfunction
  3. Read malfunction
  4. Mechanical malfunction
B15B5
When one of the conditions below is met:
  1. Mechanical communication error
  2. Load/Eject malfunction
  3. Read malfunction
  4. Mechanical malfunction
B15B7
"Bluetooth" module malfunction

INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)