Home › General › MAINTENANCE › BODY

BODY > GENERAL MAINTENANCE



1. INSPECT TIRE AND INFLATION PRESSURE
  1. Check the tires for wear and proper inflation pressure (Click here).



2. INSPECT LIGHTS, HORN, WIPERS AND WASHERS


3. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
  1. Where necessary, tighten all the parts of the chassis.

    1. Front axle and suspension
    2. Drivetrain
    3. Rear axle and suspension
    4. Brake system
    5. Engine mounting, etc

  1. Where necessary, tighten all parts of the body.

    1. Seat belt system
    2. Seat
    3. Doors and hood
    4. Body mounting
    5. Fuel tank
    6. Exhaust pipe system, etc



4. CLEAN OR REPLACE AIR CONDITIONING FILTER
  1. Remove the air conditioning filter (air refiner element) (Click here).

  1. If the clean air filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.

  1. Some filters are not able to be cleaned.

    NOTICE:
    Some filters are not able to be cleaned.



5. INSPECT REFRIGERANT AMOUNT FOR AIR CONDITIONER
  1. Check the refrigerant pressure (Click here).



6. FINAL INSPECTION
  1. Check the operation of the body parts.

    1. Hood

      1. Auxiliary catch operates properly.
      2. Hood locks securely when closed.

    2. Front and rear doors

      1. Door locks operate properly.
      2. Door close properly.

    3. Back door

      1. Door locks operate properly.
      2. Door closes properly.

    4. Seats

      1. Seat adjusts easily and locks securely in any position.
      2. Front seatback locks securely in any position.
      3. Folding-down rear seatbacks lock securely.

    5. Be sure to deliver a clean vehicle. Especially check:

      1. Steering wheel
      2. Shift lever knob
      3. All switch knobs
      4. Door handles
      5. Seats