Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B1585    USB Device Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC Code
DTC Detection Condition
Trouble Area
B1585
USB Device Malfunction
  1. Non mass-storage class or incompatible protocol USB device
  2. USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT)
  3. "iPod" malfunction
  4. "iPod" with unsupported firmware
  5. Unsupported "iPod" model
  1. USB device or "iPod"
  2. Navigation receiver assembly

INSPECTION PROCEDURE

1.REPLACE USB DEVICE OR “iPod”
  1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

  1. Turn the ignition switch off.

    HINT:
    When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

  1. Turn the ignition switch to ACC.

  1. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

    HINT:
    1. If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
    2. Refer to System Description for compatible formats and versions (Click here).


NEXT


2.CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    OK:
    No DTCs are output.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USB DEVICE OR "iPod" IS DEFECTIVE