Home › Vehicle Interior › HEATING / AIR CONDITIONING › COOLING BOX CONTROL SWITCH

COOLING BOX CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT COOLER CONTROL SWITCH ASSEMBLY


    I105746E02
  1. Check that the switch functions.
    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Control Switch Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (+S) - 3 (-S)
      Pushed
      Below 1 Ω
      6 (+S) - 3 (-S)
      Free
      10 kΩ or higher

      If the result is not as specified, replace the cooler control switch.



    I105746E03
  1. Check that the switch illuminates.
    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Control Switch Assembly)

    1. Apply battery voltage to the cooler control switch and check that the switch illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 5 (ILL+)
      Battery negative (-) → 4 (ILL-)
      Illuminates

      If the result is not as specified, replace the cooler control switch.



    I105746E04
  1. Check that the switch indicator comes on.
    Text in Illustration 
    *a
    Component without harness connected
    (Cooler Control Switch Assembly)

    1. Apply battery voltage to the cooler control switch and check that the switch indicator comes on.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → 2 (IND)
      Battery negative (-) → 7 (IND-)
      Comes on

      If the result is not as specified, replace the cooler control switch.