Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B1579    Voice Recognition Microphone Disconnected

for Preparation Click here


DESCRIPTION

The navigation receiver assembly and roof console box assembly (telephone microphone assembly) are connected to each other using the microphone connection detection signal lines.
This DTC is stored when a microphone connection detection signal line is disconnected.

DTC Code
DTC Detection Condition
Trouble Area
B1579
Telephone microphone signal is lost.
  1. Roof console box assembly
  2. Telephone microphone assembly
  3. Navigation receiver assembly
  4. Harness or connector

WIRING DIAGRAM


E259239E01


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY


    E259819E03
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I53-19 (MIN-) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Component with harness connected
    (Navigation Receiver Assembly)



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the I53 navigation receiver assembly connector.

  1. Disconnect the U7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I53-6 (SNS2) - U7-14 (SGND)
    Always
    Below 1 Ω
    I53-19 (MIN-) - U7-8 (MIC-)
    Always
    Below 1 Ω
    I53-6 (SNS2) - Body ground
    Always
    10 kΩ or higher
    I53-19 (MIN-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT ROOF CONSOLE BOX ASSEMBLY


    E160706E02
  1. Remove the roof console box assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    14 (SGND) - 8 (MIC-)
    Always
    Below 1 Ω



NG
Go to step 4
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)  

4.CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a new or normally functioning one (Click here).

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs and check if the same DTC is output again.

    OK:
    No DTCs are output.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)