Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SENSOR

BLIND SPOT MONITOR SENSOR > REMOVAL

for Preparation Click here



1. REMOVE REAR BUMPER COVER
(Click here)


2. REMOVE BLIND SPOT MONITOR SENSOR LH


    E230021
  1. Remove the 3 nuts.



    E230022
  1. Disconnect the connector and remove the blind spot monitor sensor LH.



3. REMOVE BLIND SPOT MONITOR SENSOR RH

HINT:
Use the same procedure described for the LH side.



4. REMOVE BLIND SPOT MONITOR BRACKET LH


    E231415
  1. Remove the screw and 2 bolts.

  1. Detach the 2 claws and remove the blind spot monitor bracket LH as shown in the illustration.



    E230024
  1. Using a clip remover, remove the grommet from the body panel.

    HINT:
    The grommet needs to be replaced with a new one because it will break when it is removed.



5. REMOVE BLIND SPOT MONITOR BRACKET RH

HINT:
Use the same procedure described for the LH side.