BLIND SPOT MONITOR SENSOR > REMOVAL |
| 1. REMOVE REAR BUMPER COVER |
| 2. REMOVE BLIND SPOT MONITOR SENSOR LH |
![]() |
Remove the 3 nuts.
![]() |
Disconnect the connector and remove the blind spot monitor sensor LH.
| 3. REMOVE BLIND SPOT MONITOR SENSOR RH |
| 4. REMOVE BLIND SPOT MONITOR BRACKET LH |
![]() |
Remove the screw and 2 bolts.
Detach the 2 claws and remove the blind spot monitor bracket LH as shown in the illustration.
![]() |
Using a clip remover, remove the grommet from the body panel.
| 5. REMOVE BLIND SPOT MONITOR BRACKET RH |