Component
| Function
|
Blind Spot Monitor Sensor
| - Consists of a 24 GHz radar module and an integrated processing module.
- Illuminates the blind spot monitor indicator on the outside rear view mirror assembly when a vehicle is present in the blind spot area.
- Changes the blind spot monitor indicator on the outer rear view mirror assembly from illuminated to blinking when a turn signal is received from the combination meter assembly.
|
Blind Spot Monitor Indicator
| Turns on or flashes based on a signal from the blind spot monitor sensor.
|
Blind Spot Monitor Main Switch Assembly (Warning Canceling Switch Assembly)
| Turns the blind spot monitor system on or off.
|
Combination Meter Assembly
| - Sends the turn signal state from the headlight dimmer switch assembly (turn signal light switch) to the blind spot monitor sensor via CAN communication.
- If the blind spot monitor system detects a malfunction signal while the blind spot monitor system operates, the multi-information display in the combination meter displays a warning message.
|
Main Body ECU (Cowl Side Junction Block LH)
| Sends the destination information to the blind spot monitor sensor via CAN communication.
|
VSC Actuator Assembly (Skid Control ECU)
| Transmits a vehicle speed signal to the blind spot monitor sensor via CAN communication.
|
ECM
| Sends the engine speed to the blind spot monitor sensor via CAN communication.
|
Steering Angle Sensor
| Detects the angle of the steering wheel and sends the resulting signals to the blind spot monitor sensor via CAN communication.
|