BLIND SPOT MONITOR SYSTEM > DTC CHECK / CLEAR |
| CHECK DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.
Turn the intelligent tester on.
Enter the following menus: Body / Blind Spot Monitor Master or Blind Spot Monitor Slave / DTC.
Check for DTCs (Click here).
| CLEAR DTC |
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the blind spot monitor main switch assembly (warning canceling switch assembly) on.
Turn the intelligent tester on.
Enter the following menus: Body / Blind Spot Monitor Master or Blind Spot Monitor Slave / DTC.
Clear the DTCs on the intelligent tester display.