BLIND SPOT MONITOR SYSTEM > OPERATION CHECK |
| BLIND SPOT MONITOR BEAM AXIS INSPECTION |
Move the vehicle to an area which can provide the space specified in the illustration to perform the beam axis inspection.

Procedure to enter the Test Mode
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the blind spot monitor main switch (warning canceling switch assembly) on.
Turn the intelligent tester on.
Switch the blind monitor sensor to Test Mode using the intelligent tester. Enter the following menus: Body / BSM / Utility / Test Mode.
![]() |
Perform the blind spot monitor beam axis inspection.
Check that the blind spot monitor indicators are not illuminated.
Place the reflector at position A.
Enter Test Mode using the intelligent tester. Move the reflector from position A to B as shown in the illustration.

After placing the reflector at the specified position, be sure to leave the inspection area quickly. Also, make sure that no objects other than the reflector are in the inspection area and check that the blind spot monitor indicator does not illuminate.
Move the reflector from position B to C as shown in the illustration.
After placing the reflector at the specified position, be sure to leave the inspection area quickly. Also, make sure that no objects other than the reflector are in the inspection area and check that the blind spot monitor indicator illuminates.
Finish Test Mode.
| CHECK BLIND SPOT MONITOR INSTALLATION |
Remove the rear bumper (Click here).
Attach a jig similar to the one shown in the illustration to the outward facing surface of the blind spot monitor sensor and check that the blind spot monitor sensor is perpendicular to the floor surface or within the allowable range.


| A | B | |
| Blind spot monitor sensor RH | 17 mm (0.67 in) | -17 mm (-0.67 in) |
| Blind spot monitor sensor LH | 8 mm (0.31 in) | -26 mm (-1.02 in) |
![]() |
Using the sensor installation stud bolt center lines as a reference, check that the stud bolts are as shown in the illustration.
| Dimension | Specified Value |
| y | 37 to 77 mm (1.46 to 3.03 in) |