Home › Vehicle Exterior › MIRROR (EXT) › OUTER REAR VIEW MIRROR GLASS

OUTER REAR VIEW MIRROR GLASS > INSPECTION

for Preparation Click here



1. INSPECT OUTER REAR VIEW MIRROR GLASS LH (w/ Blind Spot Monitor)

NOTICE:
Do not apply battery voltage to terminal 3 or 6 of the EC mirror.



    B284120E01
  1. Check the blind spot monitor indicator operation.

    1. Connect a positive (+) lead from the battery to terminal 7 (+) and a negative (-) lead to terminal 5 (-).

    2. Check that the blind spot monitor indicator comes on.

      OK:
      blind spot monitor indicator comes on.

      Text in Illustration 
      *a
      Component without harness connected
      (Outer rear view mirror glass LH)
      If the result is not as specified, replace the outer rear view mirror glass LH.



2. INSPECT OUTER REAR VIEW MIRROR GLASS RH (w/ Blind Spot Monitor)

NOTICE:
Do not apply battery voltage to terminal 3 or 6 of the EC mirror.



    B289637E01
  1. Check the blind spot monitor indicator operation.

    1. Connect a positive (+) lead from the battery to terminal 7 (+) and a negative (-) lead to terminal 5 (-).

    2. Check that the blind spot monitor indicator comes on.

      OK:
      blind spot monitor indicator comes on.

      Text in Illustration 
      *a
      Component without harness connected
      (Outer rear view mirror glass RH)
      If the result is not as specified, replace the outer rear view mirror glass RH.