Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM

REAR SEAT ENTERTAINMENT SYSTEM > Sound Signal Circuit between Radio Receiver and Television Display Assembly

for Preparation Click here


DESCRIPTION

The television display assembly sends the sound signal to the radio and display receiver assembly through this circuit.
The sound signal that has been sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and display receiver assembly or speakers.

WIRING DIAGRAM


E286165E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEVISION DISPLAY ASSEMBLY)
  1. Disconnect the I57 radio and display receiver assembly connector.

  1. Disconnect the U13 television display assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I57-4 (CDL+) - U13-7 (L1+)
    Always
    Below 1 Ω
    I57-5 (CDL-) - U13-8 (L1-)
    Always
    Below 1 Ω
    I57-2 (CDR+) - U13-9 (R1+)
    Always
    Below 1 Ω
    I57-3 (CDR-) - U13-10 (R1-)
    Always
    Below 1 Ω
    I57-4 (CDL+) - Body ground
    Always
    10 kΩ or higher
    I57-5 (CDL-) - Body ground
    Always
    10 kΩ or higher
    I57-2 (CDR+) - Body ground
    Always
    10 kΩ or higher
    I57-3 (CDR-) - Body ground
    Always
    10 kΩ or higher
    U13-11 (SLD1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)