Home › DRIVE LINE › DRIVE SHAFT › REAR DRIVE SHAFT (for 4WD)

REAR DRIVE SHAFT (for 4WD) > REMOVAL

for Preparation Click here



1. REMOVE REAR WHEEL


2. REMOVE TAIL EXHAUST PIPE ASSEMBLY
  1. Remove the 2 bolts.



  1. Disconnect the 4 exhaust pipe supports and remove the tail exhaust pipe assembly.


    A162161

  1. Remove the gasket from the center exhaust pipe assembly.



3. SEPARATE REAR SPEED SENSOR
  1. Remove the bolt and the speed sensor from the axle carrier.

    NOTICE:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from adhering to the speed sensor.



4. REMOVE REAR AXLE SHAFT NUT


    F045049E02
  1. Using SST and a hammer, unstake part of the axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While apply the brakes, remove the axle shaft nut.



5. REMOVE REAR DRIVE SHAFT ASSEMBLY LH


    C097746E01
  1. Place matchmarks on the drive shaft and differential side gear shaft.

  1. Remove the 4 nuts and washers, and disconnect the drive shaft from the differential side gear shaft.

  1. Remove the drive shaft from the axle carrier.



6. SECURE REAR AXLE ASSEMBLY


C066030E01

NOTICE:
  1. After disconnecting the drive shaft from the axle hub, work carefully so as not to damage the ABS speed sensor rotor serration on the drive shaft.
  2. The hub bearing could be damaged if it is subjected to the vehicle weight, such as when moving the vehicle with the drive shaft removed. Therefore, if it is absolutely necessary to place the vehicle weight on the hub bearing, first support it with SST.

SST
09608-16042   (09608-02021, 09608-02041)