REAR DRIVE SHAFT (for 4WD) > REASSEMBLY |
| 1. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT |
![]() |
Install new outboard joint boot, 2 outboard joint boot clamps, 2 inboard joint boot clamps and inboard joint boot.
Make sure that the 2 boots are on the shaft groove.
| 2. INSTALL REAR DRIVE SHAFT OUTBOARD JOINT BOOT CLAMP |
![]() |
Hold the drive shaft lightly in a soft vise.
Install the 2 outboard joint boot clamps to the boot.
Place SST onto the 2 outboard joint boot clamps.
Tighten the SST so that the 2 outboard joint boot clamps is pinched.
![]() |
Using a SST, measure the clearance of the 2 outboard joint boot clamps.
| 3. INSTALL REAR DRIVE SHAFT INBOARD JOINT ASSEMBLY |
![]() |
Through a new inboard joint boot, 2 new inboard joint clamps and cage.
Align the matchmarks, using a brass bar and a hammer, install the inner race.
![]() |
Using a snap ring expander, install a new rear drive shaft snap ring.
![]() |
Align the matchmarks, install the cage to the inner race.
Install the 6 balls with grease to the inner race.
Pack the inboard joint shaft and boot with grease in the boot kit.
![]() |
Align the matchmarks, install the inboard joint assembly to the outboard joint shaft assembly.
Install the clip.
| 4. INSTALL REAR DRIVE SHAFT INBOARD JOIN BOOT |
Install the inboard joint boot to the rear drive shaft inboard joint.
| 5. INSTALL REAR DRIVE SHAFT INBOARD JOINT BOOT CLAMP |
![]() |
Using a screwdriver, install the No. 2 rear drive shaft inboard joint boot clamp.
Install the inboard joint boot clamp by the same procedures as the No. 2 rear drive shaft inboard joint boot clamp.