Vehicle Condition
| Auto Cancel Condition
| Re-operation Condition
|
CRUISE main indicator light blinks
| - There is an open or short in the stop light switch circuit
- There is a problem with the vehicle speed signal
- There is a problem with the throttle position sensor and motor
| Turn cruise control main switch on again
|
CRUISE main indicator light blinks
| - There is a problem with the input circuit of the stop light switch circuit
- There is a problem with the cancel circuit
| Turn ignition switch off then ON again
|
Cruise control is cancelled (The indicator light remains on)
| Under the following conditions, the stored vehicle speed is maintained.
- Vehicle speed is lower than the low speed limit (approx. 40 km/h (25 mph)) while the running with the cruise control on
- VSC operates
| Push cruise control main switch to + (ACCEL)/RES (RESUME)
|
- Vehicle speed is lower than the stored speed by approx. 16 km/h (10 mph) or more
| Push cruise control main switch to - (COAST)/SET
|