Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System) > IG Power Source Circuit

for Preparation Click here


DESCRIPTION

The main power source is supplied to the A/C amplifier when the ignition switch is turned to the ON position.
The power source is used for operating the A/C amplifier and servo motor, etc.

WIRING DIAGRAM


E174502E01


INSPECTION PROCEDURE

HINT:
Start the engine before inspection. Check the IG1 relay or battery if the engine does not start.

1.INSPECT FUSE (HTR)
  1. Remove the HTR fuse from the driver side junction block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    HTR fuse
    Always
    Below 1 Ω



NG
REPLACE FUSE (HTR)
OK


2.INSPECT A/C AMPLIFIER (IG - GND)


    E147476E03
  1. Remove the A/C amplifier with its connectors still connected.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A9-18 (IG) - A9-1 (GND)
    Ignition switch: ON
    11 to 14 V



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BATTERY)


    E143742E46
  1. Disconnect the connector from the A/C amplifier.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A9-18 (IG) - Body ground
    Ignition switch: LOCK
    Below 1 V
    Ignition switch: ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - BODY GROUND)


    E143742E47
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A9-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE A/C AMPLIFIER