Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:



4. REMOVE REAR DOOR SCUFF PLATE LH

HINT:



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

HINT:



6. REMOVE REAR DOOR WEATHERSTRIP LH

HINT:
When reinstalling the weatherstrip, completely remove the sealer adhering to the opening flange on the body side beforehand.



7. REMOVE LAP BELT OUTER ANCHOR COVER LH


8. REMOVE CENTER PILLAR GARNISH LOWER LH


    B066509
  1. Remove the floor anchor cover.

  1. Remove the bolt and disconnect the front seat outer belt on the floor anchor side.



    B066496E01
  1. Using a screwdriver, disengage the 5 clips and remove the pillar garnish.

    HINT:
    Tape the screwdriver tip before use.

  1. w/ power slide door:
    Disconnect the power slide door control switch RH connector.



9. REMOVE FRONT SEAT OUTER BELT ASSEMBLY

NOTICE:
  1. Removal operation concerning the seat belt with the pretensioner must be started in 90 seconds or more after the ignition switch is turned OFF and the battery negative terminal is disconnected.
  2. Carefully read the notices for the "pretensioner" in the SRS airbag system and the outer belt assembly.

  1. Remove the floor anchor cover.

  1. Remove the bolt and the front seat outer belt assembly on the floor anchor side.

  1. Remove the nut and the front seat outer belt assembly on the shoulder anchor side.



    B069495
  1. Disconnect the pretensioner connector, as shown in the illustration.

  1. Remove the 2 bolts and front seat outer belt assembly.



10. REMOVE SIDE AIRBAG SENSOR LH
  1. Disconnect the connector from the side airbag sensor LH.



    H042693
  1. Remove the 2 nuts and the side airbag sensor LH.