Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE REAR DOOR SCUFF PLATE RH


    B066493E01
  1. Using a screwdriver, disengage the 8 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DOOR WEATHERSTRIP RH

HINT:
When reinstalling the weatherstrip, completely remove the sealer adhering to the opening flange on the body side beforehand.



5. REMOVE BACK DOOR WEATHERSTRIP

HINT:



6. REMOVE BACK DOOR SCUFF PLATE


    B066499E01
  1. Remove the 3 bolts.

  1. Using a screwdriver, disengage the 6 clips and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



7. REMOVE LAP BELT OUTER ANCHOR COVER


8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH


    B066511
  1. Remove the floor anchor cover.

  1. Remove the bolt and disconnect the No. 2 rear seat outer belt assembly on the floor anchor side.

  1. Remove the 2 package holder net hooks.

  1. Using a screwdriver, disengage the claw and remove the courtesy light.

  1. Disconnect the courtesy light connectors.



    B066503E01
  1. Using a screwdriver, disengage the 16 clips and remove the quarter trim panel assembly.

    HINT:
    Tape the screwdriver tip before use.



9. REMOVE AIR DUCT ASSEMBLY
  1. Remove the screw and the air duct assembly.



10. REMOVE REAR AIRBAG SENSOR LH
  1. Disconnect the connector from the rear airbag sensor LH.



    H042782
  1. Remove the 2 bolts and the rear airbag sensor LH.