Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CENTER AIRBAG SENSOR ASSEMBLY

CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER LH


    B066070E01
  1. Remove the 2 bolts <A>.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the 2 claws and 3 clips, and then remove the instrument panel finish panel sub-assembly lower LH.

  1. Disconnect the connectors.



4. REMOVE FLOOR CARPET COVER CENTER LH


    B066701E01
  1. Remove the clip on the floor carpet cover center LH.

  1. Depress the edge of the floor carpet cover center LH around the claws to disengage the two claws under beneath of the floor carpet cover center LH.

  1. Slightly sliding the floor carpet cover center LH to the front of the vehicle, detach the two claws from the instrument cluster finish panel sub-assembly lower center at the floor carpet cover center LH.

  1. Remove the floor carpet cover center LH.



5. REMOVE FLOOR CARPET COVER CENTER RH

HINT:
Use the same procedures for the floor carpet cover center RH and floor carpet cover center LH.



6. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B066073E01
  1. Push the right side wall and then push the left wall to release the stoppers.



    B066074
  1. Pull the glove compartment door sub-assembly rearward to remove it.



7. REMOVE INSTRUMENT PANEL BOX NO.2


    B066075E01
  1. Disengage the 2 claws and the 4 clips, and remove the instrument panel box No. 2.



8. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


    B066703E01
  1. Remove the screw <C>.

  1. Disengage the 5 clips and the claw from the lowest part on the instrument cluster finish panel assembly center in order.

  1. Disconnect the connectors at the instrument cluster finish panel sub-assembly lower center, and then remove the instrument cluster finish panel assembly center.



9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY LOWER CENTER


    B066704E01
  1. Remove the 2 clips on both sides.

  1. Remove the 3 screws <C> and 3 bolts <A>.

  1. Pull the instrument cluster finish panel sub-assembly lower center rearward to remove it.

  1. Disconnect the connector.



10. REMOVE AIR DUCT NO.4 REAR


11. REMOVE AIR DUCT NO.3 REAR


12. REMOVE AIR DUCT NO.1 REAR


13. REMOVE CENTER AIRBAG SENSOR ASSEMBLY


    H042688
  1. Disconnect the 3 connectors from the center airbag sensor assembly.

  1. Remove the 3 bolts and the center airbag sensor assembly.