Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT PASSENGER AIRBAG ASSEMBLY

FRONT PASSENGER AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD


4. REMOVE STEERING WHEEL NO.3 COVER LOWER
  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



5. REMOVE STEERING WHEEL NO.2 COVER LOWER
  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



6. REMOVE STEERING PAD


    H042695E01
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042674
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



7. REMOVE STEERING WHEEL ASSEMBLY


    F044997E02
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



8. REMOVE STEERING COLUMN COVER


    F044998
  1. Remove the 2 screws and steering column cover.



9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY


    B066073E01
  1. Push the right side wall and then push the left wall to release the stoppers.



    B066074
  1. Pull the glove compartment door sub-assembly rearward to remove it.



10. REMOVE INSTRUMENT PANEL BOX NO.2


    B066075E01
  1. Disengage the 2 claws and the 4 clips, and remove the instrument panel box No. 2.



11. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR


    H042990
  1. Disconnect the connector from the front passenger airbag assembly.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.



12. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY
  1. Remove the 4 bolts <A> <B> and 2 screws <C> and a nut <E>.

  1. Disconnect the connectors.



  1. Remove the instrument panel sub-assembly w/ passenger airbag assembly.


    B066708E01



13. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY


    H042680
  1. Remove the 2 screws.



    H042681E01
  1. Release the front side wall of the airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly rearward.

  1. Release the rear side wall of the airbag door from the other hook and remove the front passenger airbag assembly.