Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. PRECAUTION

CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.



3. REMOVE STEERING PAD

HINT:
(Click here)



4. REMOVE STEERING WHEEL ASSEMBLY


    F044997E02
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)



5. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

HINT:
(Click here)



6. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (Click here).



7. REMOVE POWER BACK DOOR UNIT ASSEMBLY


    H042991
  1. Remove the 3 bolts and the power back door unit assembly.



    H042992
  1. When replacing the RH side follow the procedure below.
    Remove the air duct rear No. 6.



8. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
  1. Disconnect the connector from the curtain shield airbag assembly LH.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the clip.



  1. Remove the 13 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.


    H042778E01