Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › CURTAIN SHIELD AIRBAG ASSEMBLY

CURTAIN SHIELD AIRBAG ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)


    H042993E01
  1. Perform a diagnostic system check (Click here).

  1. With the curtain shield airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the front pillar garnish RR window side garnish assembly No. 2 or roof headlining assembly with a new one:

    1. Cuts, minute cracks or marked discoloration on the front pillar garnish RR window side garnish assembly No. 2 or roof headlining assembly around the curtain shield airbag assembly.



2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)


    H042673E01
  1. Perform a diagnostic system check (Click here).

  1. With the curtain shield airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the curtain shield airbag assembly with a new one:

    1. Cuts, minute cracks or marked discoloration on the curtain shield airbag assembly.
    2. Cracks or other damage to the connector.

    CAUTION:
    Be sure to follow the correct removal and installation procedures.