SLIDING ROOF SYSTEM > INITIALIZATION |
| RESET SLIDING ROOF MOTOR |
If the AUTO operation function does not operate, reset the sliding roof motor using any of the following methods.
Press the sliding roof switch on the TILT UP side and hold it until the sliding roof motor stops. Then release the switch and leave it untouched for 10 seconds or more.
Press the sliding roof switch on the TILT UP side again for 10 seconds or more and hold it until the sliding roof stops at the fully open and up position.
Release the switch, press it again within 5 seconds and hold it until a series of movements indicated below has done:
Fully closing → Fully opening → Fully closing