DYNAMIC LASER CRUISE CONTROL SYSTEM > DIAGNOSIS SYSTEM |
| DIAGNOSIS FUNCTION |
![]() |
The diagnosis function makes the light and the multi-information display come on, and the CRUISE main indicator light blink as shown in the illustration. When a malfunction occurs in the dynamic laser cruise control system, the DTCs are stored in the ECM.
![]() |
| DESCRIPTION |
The ECM controls the dynamic laser cruise control system of the vehicle. The data and DTCs relating to the dynamic laser cruise control system can be read from the DLC3 of the vehicle. If the CRUISE main indicator light does not come on after the DTC check, there may be a problem with either the combination meter or the CAN communication and multiplex communication systems. Use the Techstream to check and solve the problem.
| CHECK DLC3 |
![]() |
The ECM uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Terminal No. (Symbols) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 11 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Ignition switch off*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch off*
| 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch off*
| 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Ignition switch off*
| 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch off*
| 6 kΩ or higher |
| CHECK INDICATOR |
![]() |
Turn the ignition switch to ON.
Check that the CRUISE main indicator light and READY indicator light come on when the cruise control main switch is turned on, and that the indicator lights go off when the main switch is turned off.
![]() |