Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › DYNAMIC LASER CRUISE CONTROL SYSTEM

DYNAMIC LASER CRUISE CONTROL SYSTEM > DTC CHECK / CLEAR

for Preparation Click here



DTC CHECK
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to the ON position.

  3. Turn the Techstream on.

  4. Enter the following menus: Powertrain / Laser Cruise / Trouble Codes.

  5. Check the details of the DTC(s) (Click here).


DTC CLEAR
  1. Connect the Techstream to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the Techstream on.

  4. Enter the following menus: Powertrain / Laser Cruise / Trouble Codes.

  5. Clear the DTCs.