DYNAMIC LASER CRUISE CONTROL SYSTEM > ROAD TEST |
| PROBLEM SYMPTOM CONFIRMATION |
![]() |
Inspect the SET function.
Turn the main switch on.
Drive at the required speed (45 km/h (28 mph) or higher).
Push the cruise control main switch to - (COAST)/SET.
After releasing the switch, check that the vehicle cruises at the set speed.
![]() |
Inspect the + (ACCEL) function.
Turn the main switch on.
Drive at the required speed (45 km/h (28 mph) or higher).
Push the cruise control main switch to - (COAST)/SET.
Check that vehicle speed increases while the cruise control main switch is pushed to + (ACCEL)/RES (RESUME), and that the vehicle cruises at the newly set speed when the switch is released.
Push the cruise control main switch to + (ACCEL)/RES (RESUME) and then release it immediately. Check that vehicle speed increases* (tap-up control).
![]() |
Inspect the - (COAST) function.
Turn the main switch on.
Drive at the required speed (45 km/h (28 mph) or higher).
Push the cruise control main switch to - (COAST)/SET.
Check that vehicle speed decreases while the cruise control main switch is pushed to - (COAST)/SET, and that the vehicle cruises at the newly set speed when the switch is released.
Push the cruise control main switch to - (COAST)/SET, and then release it immediately. Check that vehicle speed decreases* (tap-down control).
![]() |
Inspect the CANCEL function.
Turn the main switch on.
Drive at the required speed (45 km/h (28 mph) or higher).
Push the cruise control main switch to - (COAST)/SET.
When performing any one of the following, check that the cruise control system is canceled and that the normal driving mode is reset.
![]() |
Inspect the RES (RESUME) function.
Turn the main switch on.
Drive at the required speed (45 km/h (28 mph) or higher).
Push the cruise control main switch to - (COAST)/SET.
Cancel the cruise control system by performing any of the above operations (other than turning the main switch off).
After pushing the cruise control main switch to + (ACCEL)/RES (RESUME) at a driving speed of more than 40 km/h (25 mph), check that the vehicle resumes the speed set prior to the cancellation.