DYNAMIC LASER CRUISE CONTROL SYSTEM > OPERATION CHECK |
| INPUT SIGNAL CHECK |
![]() |
Connect the Techstream to the DLC3.
Check the cruise control main switch using the Data List function in the Techstream (ON-OFF, CANCEL, - (COAST)/SET, + (ACCEL)/RES (RESUME), and MODE).
| INSPECT MODE SWITCH |
![]() |
Turn the ignition switch to ON.
![]() |
Turn the cruise control main switch on. Then push the main switch to MODE for 1 second or more to change to the constant speed control mode. Check that "NORM." is indicated on the display.
| INSPECT STEERING PAD SWITCH ASSEMBLY |
Turn the ignition switch to ON.
Turn the cruise control main switch on.
Turn on the distance control switch of the steering pad switch.
![]() |
Check that the indication of the vehicle-to-vehicle distance, which is shown on the multi-information display on the combination meter, changes from long to middle to short in that order.