Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)

DTC    B1451/51    Compressor Solenoid Circuit

for Preparation Click here


DESCRIPTION

In this circuit, the compressor receives a refrigerant compression demand signal from the A/C amplifier.
Based on this signal, the compressor changes the amount of compressor output.

DTC No.
DTC Detection Condition
Trouble Area
B1451/51
Open or short in solenoid of externally changeable compressor circuit
  1. A/C compressor
  2. Harness or connector between A/C amplifier and solenoid of externally changeable compressor
  3. A/C amplifier

WIRING DIAGRAM


E116880E08


INSPECTION PROCEDURE

1.INSPECT A/C COMPRESSOR


    E116970E11
  1. Disconnect the A/C compressor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A32-2 (SOL+) - A32-1 (SOL-)
    20°C (68°F)
    10 to 11 Ω



NG
REPLACE A/C COMPRESSOR
OK


2.CHECK HARNESS AND CONNECTOR (A/C COMPRESSOR - BODY GROUND)


    E116971E16
  1. Disconnect the A/C compressor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A32-1 (SOL-) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (A/C COMPRESSOR - A/C AMPLIFIER)


    E116971E17
  1. Disconnect the A/C compressor connector.



    E143742E43
  1. Disconnect the A/C amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A9-4 (SOL+) - A32-2 (SOL+)
    Always
    Below 1 Ω
    A9-4 (SOL+) - Body ground
    Always
    10 kΩ or higher

    Result:
    Result
    Proceed to
    NG
    A
    OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE)
    B
    OK (When troubleshooting according to the DTC)
    C



B
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C
REPLACE A/C AMPLIFIER
A

REPAIR OR REPLACE HARNESS OR CONNECTOR