GARAGE DOOR OPENER SYSTEM > REGISTRATION |
| 1. REGISTRATION TRANSMITTER CODE |
After the dome lamp assembly No.1 has been replaced, register transmitter codes with the garage door opener (Registration mode).
![]() |
Select a garage door opener switch for transmitter code registration.
Press and hold the selected switch for 20 seconds. Then, the garage door opener enters registration mode.
![]() |
After the garage door opener has entered registration mode, bring the original transmitter of the system within 1 inch of the garage door opener while pressing the switch of the garage door opener. Under this condition, press the original transmitter.
When the transmitter code registration has been completed correctly, the indicator of the garage door opener flashes at a cycle of 5.6 Hz. When this happens, release both the switch and the original transmitter.

![]() |
Erase the transmitter codes (Clear mode).
Press and hold the 2 switches at both ends of the garage door opener simultaneously for 20 seconds. Then, the indicator starts flashing at a cycle of 5.6 Hz. Releasing the switches will end clear mode.

Low power mode:
If the switch of the garage door opener is held for 75 seconds or more, the garage door opener will enter low power mode to economize the power consumption. When the garage door opener has entered low power mode, the indicator goes off.