AUTOMATIC TRANSAXLE SYSTEM > DTC CHECK / CLEAR |
| DTC CHECK (NORMAL MODE) |
Checking DTCs using Techstream.
Turn the ignition switch off.
Connect Techstream to the DLC3.
Turn the ignition switch to the ON position and turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Use Techstream to check the DTCs and freeze frame data and note them down (For operating instructions, see the Techstream's instruction book).
| DTC CLEAR |
When using Techstream: Clearing the DTCs.
Connect Techstream to the DLC3.
Turn the ignition switch to the ON position and turn the Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Clear.
When not using Techstream: Clearing the DTCs.
Disconnect the battery terminal or remove the EFI and ETCS fuses from the engine room J/B for 60 seconds or more. However, if you disconnect the battery terminal, perform do the "INITIALIZE" procedure.