Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0705    Transmission Range Sensor Circuit Malfunction (PRNDL Input)

for Preparation Click here


DESCRIPTION

The park/neutral position switch detects the shift lever position and sends signals to the ECM.

DTC No.
DTC Detection Condition
Trouble Area
P0705
(A) Any 2 or more signals of the following are ON simultaneously (2-trip detection logic)
  1. P input signal is ON.
  2. N input signal is ON.
  3. R input signal is ON.
  4. D input signal is ON.
(B) Any 2 ore more signals of the following are ON simultaneously (2-trip detection logic)
  1. NSW input signal is ON.
  2. R input signal is ON.
  3. D input signal is ON.
(C) Any of following conditions is met for 2.0 sec. or more in the S position (2-trip detection logic).
  1. NSW input signal is ON.
  2. P input signal is ON.
  3. N input signal is ON.
  4. R input signal is ON.
(D) All switches are OFF simultaneously for NSW, P, R, N and D.
  1. Open or short in park/neutral position switch circuit
  2. Park/neutral position switch
  3. ECM

HINT:
After confirming DTC P0705, use the Techstream to confirm the PNP switch signal: Powertrain / Engine and ECT / Data List.


WIRING DIAGRAM

Refer to DTC P0705 for 2WD model or 4WD model .

INSPECTION PROCEDURE

Refer to DTC P0705 for 2WD model or 4WD model .

HINT:
Read freeze frame data using the Techstream or OBD II scan tool. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was LEAN or RICH, and other data from the time the malfunction occurred.