POWER WINDOW CONTROL SYSTEM (w/ Jam Protection Function) > DIAGNOSIS SYSTEM |
| CHECK DLC3 |
![]() |
The vehicle's ECU uses ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format.
| Symbols (Terminal No.) | Terminal Description | Condition | Specified Condition |
| SIL (7) - SG (5) | Bus "+" line | During transmission | Pulse generation |
| CG (4) - Body ground | Chassis ground | Always | Below 1 Ω |
| SG (5) - Body ground | Signal ground | Always | Below 1 Ω |
| BAT (16) - Body ground | Battery positive | Always | 10 to 14 V |
| CANH (6) - CANL (14) | CAN bus line | Ignition switch OFF*
| 54 to 69 Ω |
| CANH (6) - CG (4) | HIGH-level CAN bus line | Ignition switch OFF*
| 200 Ω or higher |
| CANL (14) - CG (4) | LOW-level CAN bus line | Ignition switch OFF*
| 200 Ω or higher |
| CANH (6) - BAT (16) | HIGH-level CAN bus line | Ignition switch OFF*
| 6 kΩ or higher |
| CANL (14) - BAT (16) | LOW-level CAN bus line | Ignition switch OFF*
| 6 kΩ or higher |
Connect the cable of Techstream to the DLC3, turn the ignition switch to the ON position and attempt to use Techstream. If the screen displays a communication error message, a problem exists in the vehicle side of the tester side.