ANTI-LOCK BRAKE SYSTEM > TC and CG Terminal Circuit |

| 1.INSPECT DLC3 (BETWEEN TC of DLC3 AND CG of DLC3) |
![]() |
Turn the ignition switch to the ON position.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| D1-13 (TC) - D1-4 (CG) | 10 to 14 V |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND TC of DLC3) |
![]() |
Turn the ignition switch off.
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-8 (TC) - D1-13 (TC) | Below 1 Ω |
| S3-8 (TC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BETWEEN CG of DLC3 AND BODY GROUND) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| D1-4 (CG) - Body ground | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND TC of DLC3) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| S3-8 (TC) - D1-13 (TC) | Below 1 Ω |
| S3-8 (TC) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||