Home › BRAKE › BRAKE CONTROL › ANTI-LOCK BRAKE SYSTEM

ANTI-LOCK BRAKE SYSTEM > FREEZE FRAME DATA

for Preparation Click here



FREEZE FRAME DATA
  1. Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
    The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from OFF to the ON position since the last time the ABS was activated.

    HINT:
    1. Freeze frame data at the time the ABS operates:
      The skid control ECU stores and updates data whenever the ABS system operates.
      When the ECU stores data at the time a DTC is detected, the data stored during ABS operation is erased.

  2. Connect Techstream to the DLC3.

  3. Turn the ignition switch to the ON position.

  4. On the tester display, select the Freeze Frame Data.

    ABS / VSC / TRAC: 
    Tester Display
    Measurement Item
    Reference Value
    Freeze DTC
    Freeze DTC (Trouble code)
    -
    Stop Light SW
    Stop light switch signal
    Stop light switch ON: ON, OFF: OFF
    Operated System
    System status
    ABS activated: ABS
    BA activated: BA
    Fail safe mode activated: FAIL SAFE
    No system activated: NO SYS
    Number of IG ON
    Number of operations of ignition switch ON after memorizing freeze frame data
    0 to 31
    Vehicle Speed
    Vehicle speed reading
    Min.: 0 mph (0 km/h), Max.: 202 mph (326.4 km/h)
    Vehicle Speed Grade
    Vehicle speed grade
    Min.: -1.869 G, Max.: 1.869 G