Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1200    MPX Body ECU Stop

for Preparation Click here


DESCRIPTION

  1. This DTC is detected when communication between the multiplex network body ECU and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1200
Body ECU communication stops
  1. Multiplex network body ECU
  2. Wire harness

WIRING DIAGRAM


C160421E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - BATTERY)


    C160698E01
  1. Disconnect the 1A and 1C junction block connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    1A-1 - Body ground
    Always
    11 to 14 V
    1C-24 (BECU) - Body ground
    Always
    11 to 14 V
    1C-30 (ALTB) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (MULTIPLEX NETWORK BODY ECU - GROUND)


    C160699E02
  1. Disconnect the 1K and 1L junction connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1K-17 (GND2) - Body ground
    Always
    Below 1 Ω
    1L-16 (GND1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160701E02
  1. Disconnect the A21, G4 and B7 ECU connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1E-7 (MPX1) - A21-22 (MPX2)
    Always
    Below 1 Ω
    B7-21 (MPX2) - G4-3 (MPD1), G4-12 (MPD2)
    Always
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND MULTIPLEX NETWORK BODY ECU

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE MULTIPLEX NETWORK BODY ECU