Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › MULTIPLEX COMMUNICATION SYSTEM

DTC    B1272    Power Seat ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is detected when communication between the seat position control ECU and the multiplex network gateway ECU stops for more than 10 seconds.

DTC No.
DTC Detection Condition
Trouble Area
B1272
Power seat ECU communication stops
  1. Seat position control ECU
  2. Wire harness

WIRING DIAGRAM


C160429E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - BATTERY)


    C160734E01
  1. Disconnect the P58 and P59 ECU connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    P59-4 (IG) - Body ground
    Ignition switch: ON
    11 to 14 V
    P59-8 (SYSB) - Body ground
    Always
    11 to 14 V
    P58-5 (+B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (SEAT POSITION CONTROL ECU - GROUND)


    C160406E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P58-1 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK COMMUNICATION LINE


    C160735E01
  1. Disconnect the G4 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P59-1 (MPX1) - G4-3 (MPD1)
    Always
    Below 1 Ω
    P59-1 (MPX1) - G4-12 (MPD2)
    Always
    Below 1 Ω

    Result:
    Result
    Proceed to
    Both are OK
    A
    One is OK
    B
    Both are NG
    C



B
REPAIR OR REPLACE HARNESS OR CONNECTOR AND SEAT POSITION CONTROL ECU

C
REPAIR OR REPLACE HARNESS OR CONNECTOR
A

REPLACE SEAT POSITION CONTROL ECU