Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › AIRBAG SYSTEM

AIRBAG SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
*: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Confirm problem symptoms (Click here).


    NEXT


    3.CHECK MULTIPLEX COMMUNICATION SYSTEM*
    1. Check if the multiplex communication system DTC is output (Click here).

      HINT:
      The center airbag sensor assembly of this system is connected to the multiplex communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the multiplex communication system.

      Result: 
      Result
      Proceed to
      Multiplex communication system DTC is not output.
      A
      Multiplex communication system DTC is output.
      B



    B.
    INSPECT MULTIPLEX COMMUNICATION CIRCUIT
    A


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the Techstream to check if the CAN communication system is functioning normally (Click here) .

      HINT:
      The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

      Result: 
      Result
      Proceed to
      The CAN communication system is functioning normally.
      A
      The CAN communication system is not functioning normally.
      B



    B.
    INSPECT CAN COMMUNICATION CIRCUIT
    A


    5.SRS WARNING LIGHT CHECK
    1. Proceed to Diagnosis System (Click here).


    NEXT


    6.CHECK FOR DTC*
    1. Proceed to DTC Check / Clear (Click here).
      Result: 
      Result
      Proceed to
      DTC is output.
      A
      DTC is not output.
      B



    B.
    GO TO STEP 8
    A


    7.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart (Click here).


    NEXT

    GO TO STEP 10


    8.SYMPTOM SIMULATION
    1. Proceed to Diagnosis System (Click here).


    NEXT


    9.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table (Click here).


    NEXT


    10.CIRCUIT INSPECTION*

      NEXT


      11.IDENTIFICATION OF PROBLEM

        NEXT


        12.REPAIR OR REPLACEMENT

          NEXT


          13.CONFIRMATION TEST

            NEXT

            END